FEP Protect - anti-adhesive spray for FEP - 50ml

FEP Protect is a special anti-adhesive spray liquid , which, properly distributed on the surface of FEP, improves the non-stick properties of the film , and at the same time extends its life. This liquid is intended for use in SLA, DLP, DPP, DayLight, UV Laser 3D printers . FEP Protect is based on nanotechnology and guarantees enhanced hydrophobicity of the film. The liquid forms on the surface a hard, transparent and invisible to the human eye smooth coating with hydrophobic properties. After curing, it does not change the transmission of UV light, the resin will still cure properly, with the same exposure times. The agent also eliminates minor scratches and scratches on the surface.

FEP Protect - release agent for FEP.

Before applying the liquid, the surface should be thoroughly washed, degreased and dried. The bottle with the liquid should be warmed in the palm of your hand. Spray the surface with liquid, and then spread over the entire surface with a soft cloth or cotton pad. The liquid should be thoroughly spread over the entire surface, so as not to leave an empty piece and not to bend or fold the foil. The entire surface should be covered with a thin film. When spreading, streaks are formed, which is a natural phenomenon. After spreading FEP Protect, allow it to dry completely and then polish it thoroughly. Start polishing when you notice dried streaks and the FEP is dull. For polishing, use a microfiber cloth and polish until the streaks are completely removed. Repeat this step every few prints or as needed.

• Middle: anti-adhesive liquid (non-stick coating)
• Type: spray
• Colour: colorless
• Capacity: 50 ml