DFRobot Gravity - rotary potentiometer 300 degrees

Rotary potentiometer for Arduino and Raspberry Pi, the rotation angle is 300 degrees. The Gravity interface supports the Plug & Play function. Working voltage is from 3.3 V to 5 V.

The device has three output pins, you need a cable with a female tip that is in the set. The pins' distribution is as shown below:

1. Signal - analog output signal
2. GND - ground of the system
3. VCC - supply voltage from 3.3 V to 5 V

The figure below shows the example of connecting the module to Arduino. To run the system, it is sufficient to indicate and to read an analog output signal from the Signal pin through the built-in into Arduino of the A/D converters (pins marked by the letter A, for example, A0).

The product is compatible with Arduino

Sample code can be found in the user guide.

• Supply voltage: from 3.3 V to 5 V
• Interface: analog
• Turn: 300 degrees
• Connection: Gravity
• Dimensions: 31 x 22 mm

• Website of the manufacturer: DFRrobot DFR0054
• User manual
• Diagram of the module