RP2040 HAT Expansion - Raspberry Pi GPIO Expansion - Pi HAT and Pico HAT - SB Components SKU24766
- Артикул:
- 102789074
Характеристики
- Вести
- 2x20
- UC - I2C
- yes
- UC - A/C
- 12-bit
- UC - USB
- USB C
- UC - PWM
- 16
- UC - UART
- yes
- Интерфейс UC - SPI
- yes
- UC - Микроконтроллер
- RP2040
Клавиатура
- Тип переключателя
- tact-switch SMD
Общие характеристики
- UC - Вспышка
- 2048 kB
- Датчик в сборе
- holes
Прочие свойства
- EAN
- 5055652924766
- Бренд
- sb components
Описание
The module based on the RP2040 microcontroller is a development board that allows you to connect HATs - including Pi HAT and Pico HAT . It allows you to use many different extensions at the same time, making it easier to test other modules. Built-in RP2040 has 2 Cortex M0+ cores clocked at 133 MHz, 2 MB QSPI Flash memory and a USB interface with a Type-C connector for programming and communication with a computer. The system is equipped with 26 GPIO pins. It is equipped with interfaces such as: 2 x I2C , 2 x SPI , 2 x UART, 16 PWM channels and 4 x ADC . Programming is done in C/C, CircuitPython and MicroPython. The board is also equipped with a Reset and Bootloader button and LEDs indicating the operating and power status of the system.
RP2040 HAT Expansion - Raspberry Pi pin expander - Pi HAT and Pico HAT - SB Components SKU24766
- Two ARM Cortex M0+ cores clocked at up to 133 MHz
- 264 kB RAM
- No built-in memory - support for external QSPI FLASH memory up to 16 MB
- DMA controller
- Built-in LDO to power the core
- 30 GPIO pins
- Interfaces:
- 2 x UARTs
- 2 x SPI
- 2 x I2C
- 16 PWM channels
- 4 x 12-bit ADC
- USB 1.1 and PHY controller
- 8 PIO state machines
HAT overlays are modules intended for installation on Raspberry Pi (Pi HAT) or Raspberry Pi Pico (Pico HAT) boards. They have standard connectors, enabling installation without the need for soldering. These include many power supply systems, sensors, pin expanders and communication modules. Their manufacturers often provide ready-to-use libraries and usage examples, making their use even easier.
- Microcontroller: RP2040
- 32-bit dual-core Cortex M0+
- 264 kB RAM
- 2 MB external FLASH QSPI memory
- 24-pin E-Paper display connector
- GPIO connectors:
- 2 x I2C, 2 x SPI, 2 x UART
- 16 PWM channels
- 4 x 12-bit ADCs
- 8 digital pins
- Reset and Bootloader buttons
- LEDs: operation and power status
- 3.3V voltage stabilizer
- Pinouts:
- Pi HAT compatible connector
- Pico HAT compatible connector
- 2 x 20 goldpin male plugs, 2.54 mm pitch
- USB Type-C
- Support for the following languages: MicroPython, CircuitPython and C/C++
- 6 mounting holes
- Manufacturer's website: SB Components SKU24766
- Technical documentation of the module
- System diagram
- Documentation of the RP2040 system
- Pinout description