nFEP film for Creality 3D printers - 297x210mm

High-quality foil used in printers that use photosensitive resin to form 3D models. It is mounted on the bottom of the vat with resin . It is used to transmit as much UV light as possible necessary to cure the resin. nFEP film is smoother than regular FEP film and does not stick to the printer's LCD screen. The use of nFEP film from Creality is a guarantee of the highest quality prints. Its dimensions are 297 x 210 mm and it is compatible with many resin printers, including: Halot-Ray, Halot-Sky , Halot-Lite , LD-006 and others with a similar working area. It is recommended to replace the film after approx. 200 hours of use.

nFEP film for Creality 3D printers.

The nFEP film is mounted on the bottom of the resin tank.

• Empty the resin tank
• Remove the tank from the printer
• Remove all screws to lift the steel frames
• Remove the old foil
• Gently peel off the protective film from the new nFEP film
• Place the new foil between the two steel frames
• Tighten all screws
• Reinstall the tank

• Manufacturer: Creality
• Spare part type: nFEP film for resin printers
• Compatible Creality 3D Printers: Halot Ray, Halot-Sky, Halot-Lite, LD-006, etc.
• UV light transmittance: approx. 95%
• Toughness: 400%
• Thermal resistance: up to 260°C
• Dimensions: 297 x 210 x 0.15mm

The dimensions of the film are 297 x 210 mm.

• Manufacturer's website