Resin for 3D printer FormFutura Platinum LCD Series 0,5kg - Solid White

Solidwhitephotopolymer resin used in open source3D printersequipped with an LCD and DLP projector. It is cured by light with wavelength rangingfrom 385 nm to 420 nm. The product emits small amounts of unpleasant odour during the printing process. Finished models obtained from FormFutura Platinum LCD Series are characterized by a high level of detail and smooth texture. A characteristic feature ofresinsfrom this line is short exposure time. Package contains0.5 kg of product.

FormFutura Platinum LCD Series Resin - Solid White.

Models made using Platinum LCDSeries resins.

• Produces low odor during printing
• Resistance to weather conditions and UV radiation
• Faster printing due to short exposure time
• Produce high-resolution, highly detailed models
• Offers vibrant, long-lasting colors without discoloration (available in translucent and opaque versions)
• Resins have low shrinkage and water absorption (absorbency)
• Used in model and figure printing and functional prototyping

• Shake the bottle for at least 2 minutes before each use.
• Then leave the resin for about 10 minutes to let the air bubbles escape from the resin
• After printing, unused resin can be transferred from the printer tank to the bottle

Always wear protective equipment when handling the resin:gogglesand nitrile gloves.

• Ready model should be rinsed in isopropyl alcohol (IPA) or bioethanol for about 5 minutes.
• The manufacturer recommends the use of ultrasonic cleaner.
• Before further curing check if the model is completely dry after rinsing
• Place the rinsed parts in a well-ventilated room for at least 30 min. (Compressed air can also be used for at least 2 minutes).
• Cure the objects in a special chamber for 20 to 30 minutes at 65°C
• Recommended curing wavelength is from 300 nm to 410 nm
• When grinding resin, respiratory protection is absolutely necessary

3D printout made with Platinum Series LCD resin.

Please note that the printing method may vary depending on the printer used, its movement geometry, settings and the method of curing the model.

• Viscosity: 500 cps at 25°C
• Density: 1.18 g/cm2

The table shows the mechanical parameters of the cured resin. Tested objects were cured for 10 minutes with high power mercury curing.

• Manufacturer's website
• Technical documentation