nFEP film for Creality 3D printers - 220x180mm
- Артикул:
- 77845051
Характеристики
Прочие свойства
- Бренд
- Creality
Описание
High-quality foil mounted on the bottom of the tank in 3D printers that use photosensitive resin to form models. It is used to transmit as much UV light as possible, necessary to cure the resin. nFEP film is very smooth and compared to regular FEP film , it does not stick to the printer's LCD screen. Replacing the foil in the printer with nFEP foil from Creality is a guarantee of improved print quality . The product is compatible with many resin printers, including: Halot One, Halot One Plus , Halot One Pro , LD-002H and others with a similar working area. The dimensions of the film are 220 x 180 mm. The manufacturer recommends replacement after approx. 200 hours of use.
nFEP film for Creality 3D printers.
The film is compatible with Creality resin printers.
- Empty the resin tank
- Remove the tank from the printer
- Remove all screws to lift the steel frames
- Remove the old foil
- Gently peel off the protective film from the new nFEP film
- Place the new foil between the two steel frames
- Tighten all screws
- Reinstall the tank
nFEP film should not be cleaned with sharp tools. This may scratch its surface.
- Manufacturer: Creality
- Spare part type: nFEP film for resin printers
- Compatible Creality 3D Printers: Halot One, Halot One Plus, Halot One Pro, LD-002H, etc.
- UV light transmittance: approx. 95%
- Toughness: 400%
- Thermal resistance: up to 260°C
- Dimensions: 220 x 180 x 0.15mm
The dimensions of the film are 220 x 180 mm.
- Manufacturer's website