MOSFET driver with N channel - for motors, solenoids, LEDs - STEMMA JST PH 2mm - Adafruit 5648

An N-channel MOSFET (also called a transistor ) driver from Adafruit , featuring the AO3406 chip. The module can be supplied with a voltage from 3 V to 30 V and controlled by a signal with a logic level from 3 V to 20 V. It also has a built-in 1N4007 protection diode.

N-channel MOSFET driver equipped with AO3406 chip.

Example connection diagram. The Raspberry Pi board and motor must be purchased separately.

• V+ - power pin. It is rated to operate from 3V to 30V. When connecting to control devices, supply the board with a logic level equal to that of the connected microcontroller - e.g. for a 5V microcontroller such as Arduino, use 5V.
• GND - common ground of the system.
• In - signal input pin.
• Out - signal output pin. It can be used to control motors, inductors, high-power LEDs, single-color LED strips or others with a continuous current consumption of up to 1.5 A and a peak current consumption of up to 3 A.

• Type: driver
• Application: for motors, electromagnets, LEDs
• Built-in chip: AO3406
• Supply voltage: from 3 V to 30 V DC
• Logic / PWM voltage: 3 V to 20 V DC
• Forward current: 1.5 A (continuous), 3 A (short)
• RdsOn: 70mOhm
• Built-in protection diode: 1N4007
• Input connector: plug-and-play JST PH (2 mm pitch)
• Output connector: screw terminals
• Board dimensions: 25.4 x 17.7 x 7.2 mm
• Weight: 2.4g

• N-channel MOSFET driver - for motors, electromagnets, LEDs - STEMMA JST PH 2 mm - Adafruit 5648 - 1 piece

MOSFET driver with N channel - for motors, electromagnets, LEDs - STEMMA JST PH 2 mm - Adafruit 5648.

• Manufacturer's website: Adafruit 5648
• User Guide
• Technical documentation of the AO3406 chip