Digispark - Attiny85 Mini Microkontroller - 5 V
Бестселлер
- Артикул:
- 43302679
4 240 AMD
Характеристики
- UC - I2C
- yes
- UC - USB
- microUSB
- UC - ядро
- 1. Single Core
- UC - частота
- 16 MHz
- UC - Вспышка
- 8 kB
- Напряжение до
- 5.0 V
- Напряжение от
- 5.0 V
- UC - аналог в
- 4
- Интерфейс UC - SPI
- yes
- UC - Микроконтроллер
- Attiny85
- Выходное напряжение от
- 5.0 V
- Выходное напряжение до
- 5.0 V
Общие характеристики
- UC - PWM
- 3
- UC - ядро
- 8-bit AVR
- UC - UART
- Нет
- UC - Разъем
- 5V microUSB
- UC - Цифровые контакты
- 6
Производительность
- Тип
- Комплектующие для микрокомпьютеров
Прочие свойства
- EAN
- 5904422342371
- Бренд
- Digispark
- Номинальное выходное напряжение
- 5.0 V
Описание
Product description: Digispark - ATtiny85Mini Microcontroller- 5V.
Specifications of the ATtiny85MiniMicrocontroller
Miniature module withATtiny85microcontroller, equipped with 8 kb flash memoryand6 I/O ports.On the board there is amicroUSBconnector, thanks to which the chip can be programmed through ArduinoIDEenvironment. Power supply voltage is5 Vorfrom 7 V to 35 V, thanks to the built-in5 V / 500 mA regulator. The product comes in two versions sent randomly, they do not differ in specification.
The product comes in two versions sent randomly, they do not differ in specification.
- ATTINA microcontroller85:
- Flash memory: 8 kb (of which 2.75 kB occupied by bootloader)
- Clock: 16 MHz
- USB bootloader with programming capability via Arduino IDE environment
- MicroUSB connector for programming, in our offer you will finda suitable cable
- The installed 5.0 V controller with a current capacity of up to 500 mA allows you to connect a supply voltage up to 35 V.
- Can be powered from a USB port or from an external source
- There are two LEDs on the board: power and for the user, connected to pin 1.
- 6 digital input/output pins, including:
- 4 ADC
- 3 channels of PWM
- I2C and SPI interface
- Two 2.1 mm diameter mounting holes
- Dimensions: 21 x 18 mm / 24 x 18 mm
- Included: goldpin connector
- Installation instructions for the PCB in Arduino IDE
- The wiki site
