VICTRON ENERGY Multiplus 24/1600/40-16 Charger
Бестселлер
- Артикул:
- 108375469
612 196 AMD
Характеристики
Прочие свойства
- Бренд
- Victron Energy
Свойства
- Цвет
- Синий
Описание
Victron Energy MultiPlus Inverter Charger 24V / 1600VA / 40 the MultiPlus is, in one compact housing a powerful sinusoidal inverter, a sophisticated battery charger with adaptive technology and an AC transfer switch at high speed.
It allows monitoring and control of the system locally (LAN) or remotely with the free app VRM.
Features:
Proven reliability the full-bridge plus toroidal transformer topology has proven its reliability over many years the Inverter is short-circuit proof and protected against overheating, whe ther due to overload or high ambient temperature.
PowerControl - Power limiting from generator, shore power or grid (800VA/1200VA).
A maximum current from the generator or the pontoon can be set on the Multi Control Panel the MultiPlus will then take over other AC loads and use the excess current for charging, thus avoiding overloading the generator or shore power.
PowerAssist - Increasing the electrical capacity of the shore power or generator (800VA/1200VA).
When a power peak is required for a short period of time, as is often the case.
The MultiPlus will immediately compensate for the possible lack of power from the mains or generator current with power from the battery.
When the load is reduced.
The excess power is used to recharge the battery.
High starting power.
Necessary for starting loads with high inrush current, such as converters for LED lamps, halogen lamps or power tools.
Search mode.
When the search mode is activated.
The Inverter consumption in no-load operation decreases by approximately 70% in this mode the Multi, when operating in inverter mode, switches off if there is no load or too little load, and switches back on every two seconds for a short period of time.
If the output current exceeds a preset level.
The Inverter will continue to operate.
otherwise.
The Inverter will switch off again.
Programmable relay the programmable relay is by default configured as an alarm relay, i.e the relay will de-energize in case of alarm or pre-alarm (inverter is too hot, input ripple is almost too high and battery voltage is too low).
Remote On/Off/Charger on connector Three-pole connector the first configuration can be done at Fusion Solar Energy at no extra charge for you to receive your fully customized equipment.
It allows monitoring and control of the system locally (LAN) or remotely with the free app VRM.
Features:
Proven reliability the full-bridge plus toroidal transformer topology has proven its reliability over many years the Inverter is short-circuit proof and protected against overheating, whe ther due to overload or high ambient temperature.
PowerControl - Power limiting from generator, shore power or grid (800VA/1200VA).
A maximum current from the generator or the pontoon can be set on the Multi Control Panel the MultiPlus will then take over other AC loads and use the excess current for charging, thus avoiding overloading the generator or shore power.
PowerAssist - Increasing the electrical capacity of the shore power or generator (800VA/1200VA).
When a power peak is required for a short period of time, as is often the case.
The MultiPlus will immediately compensate for the possible lack of power from the mains or generator current with power from the battery.
When the load is reduced.
The excess power is used to recharge the battery.
High starting power.
Necessary for starting loads with high inrush current, such as converters for LED lamps, halogen lamps or power tools.
Search mode.
When the search mode is activated.
The Inverter consumption in no-load operation decreases by approximately 70% in this mode the Multi, when operating in inverter mode, switches off if there is no load or too little load, and switches back on every two seconds for a short period of time.
If the output current exceeds a preset level.
The Inverter will continue to operate.
otherwise.
The Inverter will switch off again.
Programmable relay the programmable relay is by default configured as an alarm relay, i.e the relay will de-energize in case of alarm or pre-alarm (inverter is too hot, input ripple is almost too high and battery voltage is too low).
Remote On/Off/Charger on connector Three-pole connector the first configuration can be done at Fusion Solar Energy at no extra charge for you to receive your fully customized equipment.
