SparkFun Qwiic SHIM Kit - kit with display for Raspberry Pi - SparkFun KIT-16987

Starter kit from SparkFun prepared to extend the capabilities of the Raspberry Pi with Qwiic connectors. It consists of a shield for GPIO pins with a Qwiic connector, display , IMU module and dedicated cables. The kit does not require soldering , so it allows for simple prototyping and allows you to quickly add new peripherals.

Elements included in the kit.

The Qwiic ecosystem includes a wide range of sensors, electronic components and peripherals that use the I2C bus to communicate with each other. They have a 4-pin connector and are connected via dedicated cables . The idea behind this solution is to facilitate and accelerate the prototyping process. All elements supporting the Qwiic standard use a common, 4-pin JST connector with a pitch of 1 mm, which, among other things, reduces the amount of space required on the PCB and does not require additional soldering of the connectors. It also protects against connection inconsistent with the polarity. The SHIM module is also equipped with a 3.3 V regulator, which allows you to connect any board with a Qwiic connector.

• Compatible with: Raspberry Pi
• SHIM Qwiic overlay
  • Regulator: 3.3V
  • Connector standard: Qwiic
  • Communication interface: I2C bus
  • Overlay format: HAT
  • No soldering required
  • Dimensions: 10.2 x 14 mm
• Display
  • Supply voltage: from 3.3 V to 9 V (3.3 V only through the Qwiic connector and pin "+")
  • Logic voltage I / O: 3.3 V
  • Communication supported: UART, I2C, SPI
  • Programmatically variable I2C address: 0x72 (default)
  • Displayed characters: black with RGB backlight
  • Dimensions: 80.29 x 35.90 x 14.09 mm
• IMU sensor
  • Gyroscope
    • 3 axes: X, Y, Z
    • Adjustable range: ± 250 dps, ± 500 dps, ± 1000 dps, ± 2000 dps
  • Accelerometer
    • 3 axes: X, Y, Z
    • Adjustable range: ± 2 g, ± 4 g, ± 8 g, ± 16 g
  • Magnetometer
    • 3 axes: X, Y, Z
    • Measuring range: up to ± 4900 µT
  • Interface: I2C, SPI
  • Frequency
    • I2C: up to 100 kHz (standard mode)
    • I2C: up to 400 kHz (fast mode)
    • SPI: up to 7 MHz for communication with registers
  • Embedded Digital Motion Processor (DMP)
  • Temperature sensor with digital output

SparkFun Qwiic SHIM Kit.

• SparkFun Qwiic SHIM - Qwiic I2C connector for Raspberry Pi - SparkFun DEV-15794
• Qwiic SerLCD 16x2 I2C display - RGB backlight - SparkFun LCD-16396
• ICM-20948 9DoF - 3-axis accelerometer, gyroscope and magnetometer I2C / SPI Qwiic - SparkFun SEN-15335
• Qwiic flexible cable with 4-pin plug - 5cm - SparkFun PRT-17260
• Qwiic flexible cable with 4-pin plug - 10cm - SparkFun PRT-17259

• The website of the manufacturer: SparkFun KIT-16987
• User Guide