Soldering station Yihua 995D+ hotair with fan - 720W
Бестселлер
- Артикул:
- 47170591
87 298 AMD
Характеристики
- Напряжение до
- 220 V AC
- Напряжение от
- 240 V AC
- Паяльник - Вентилятор
- yes
- Кондиционер паяного типа
- Цифровой
- Припой - показания реальной температуры
- yes
Общие характеристики
- Припой - Горячий воздух
- yes
Прочие свойства
- Бренд
- YIHUA
Свойства
- Температура
- 200 - 480 °C
Энергопитание
- Номинальная мощность
- 720 W
- Номинальное напряжение
- 230 V AC
Описание
Description
WEP 995D+ soldering station with hot air iron and soldering iron. The device is equipped with PID controller that checks the performance and adjusts it to the preset values.
Specification
- Voltage: 220 - 240 V / 50 Hz (network)
- Power: 720 W
- The device has a PID controller
- Compact design with clear LCD display
- Automatic cooling when you put down the iron
- Sleep function
- Technology ESD Safe
- Soldering Iron Hotair:
- Adjustable temperature hot air from 100 - 480 °C
- Temperature stability +/-1 °C
- LCD display
- Temperature setting buttons
- Smooth adjustmentof temperature in the range
- Air flow up to 120 l/min
- Długość cable bulb: up to 90 cm
- The air blow is realized through a fan located in the iron
- Tip-based Soldering Iron
- Adjustable temperature soldering tip: 200°Cto 480 °C
- Temperature stability: +/- 1 °C
- Soldering iron power: from 50 to 100 W
- The resistance to ground of up to 2 Ohms
- Potencjał relative to earth ground 2 mV
- System: ESD safe
- Mode sleep: activated after idle operation 0-99 minutes.
- Iron: 907L
Includes:
- Station Yihua 995D+
- Hotair iron stand
- Set of nozzles:
- round with a diameter of 4.4 mm
- round with a diameter of 8 mm
- round with a diameter of 9 mm
- square 12x12 mm
- Stand for soldering iron along with a cleaning sponge
- Soldering iron with T-I tip
- A gripper for lifting circuits
- Power cable
- Manual
First run
- You should not run the device immediately after delivery.
- Equipment must remain for about 12 hours at room temperature before switching on.
- All complaints caused by running of the equipment too soon will be denied.
- You must completely remove the screw/screws from the bottom of the station if the compressor is the source of air supply. These screws are marked in red (1 or 3 screws depending on model).
Our range of accessories for soldering:
- soldering tin of various diameters
- fluxes and rosins
- braids to remove excess tin
- suckers
- soldering tips
- tweezers, holders, magnifying glass
- sponges and cleaners
