„Soldering station hotair and tip-based 2in1 Yihua 902A - 700W

Soldering iron Yihua 902D with a total capacity of 700 wattswith adjustable temperature controller,PID.The device has higher heating power 50W. Temperature of the soldering iron and the hotair iron is set by using the knobs.

The station is used in the electronic repair services for safe soldering of QFP, BGA, SMD,PLCC, and other sensitive elements on temperature.

Check out our offer of additional tips!

• Supply voltage: 230 V / 50 Hz (network)
• Power: 700 W
• Station is controlled through the microcontroller for PID control, which ensures high stability
• The station has an ergonomical body

• Adjustable temperature hot air from 100°Cto 450 °C
• Temperature stability: +/- 1 °C
• Temperature setting with knob
• Air consumption: max. up to 120 litres/minute

• Adjustable temperature of soldering tip: 200°Cto 480 °C
• Temperature stability: +/- 2 °C
• Soldering iron power: 50 W

• Soldering station Yihua 902A
• Stand the flask hotair
• Set of nozzlez:
  • round nozzle with a diameter of 6 mm
  • round nozzle with a diameter of 9 mm
  • square 12 x 12 mm
• Soldering iron stand along with a cleaning sponge
• Soldering iron 907A with T-I tip
• Gripper for lifting circuits

Firstrun

• You should not run the device immediately after delivery.
• Equipment must remain for about 12 hours at room temperature before switching on.
• All complaints caused by running of the equipment too soon will be denied.

• You must completely remove the screw/screws from the bottom of the station if thecompressor is the source of air supply. These screws are marked in red (1 or 3 screws depending on model).

Note

Heating elements (heaters) and tips are not subject to warranty, you should purchase new ones.

• soldering tin of various diameters
• fluxes and rosins
• braids to remove excess tin
• suckers
• soldering tips
• tweezers, holders, magnifying glass
• sponges and cleaners