Soldering station hotair and tip-based 2in1 Yihua 872D+ - 700W
Бестселлер
- Артикул:
- 47170593
51 203 AMD
Характеристики
Общие характеристики
- Напряжение до
- 220 V AC
- Напряжение от
- 240 V AC
- Паяльник - Вентилятор
- Нет
- Припой - Горячий воздух
- yes
- Кондиционер паяного типа
- Цифровой
- Припой - показания реальной температуры
- yes
Прочие свойства
- Бренд
- YIHUA
Свойства
- Температура
- 100 - 480 °C
Энергопитание
- Номинальная мощность
- 700 W
- Номинальное напряжение
- 230 V AC
Описание
Description
Includes:
Soldering iron Yihua 872D total capacity of 700 watts with adjustable temperature and built-in PID-regulator. The device has a soldering iron with heating power 50 W. Temperature of soldering iron and hotair iron is set by using the knobs.
The station is used on the electronic repair services for safe soldering of QFP, BGA, SMD,PLCC, and othertemperature-sensitive elements.
Check out our offer of additional tips!
Specification- Supply voltage: 230 V / 50 Hz (network)
- Power: 700 W
- Station is controlled through the microcontroller for PID control, which ensures high stability
- Two LED displays the value of the tip and hotair, every few seconds displays the current temperature
Hotair Soldering Iron
- Adjustable temperature hot air from 100 °C to 480 °C
- Temperature stability: +/- 1 °C
- Temperature setting with knob
- Air consumption: max. up to 24 l/min
- Display: LCD
Tip-based Soldering Iron
- Adjustment of the soldering tip temperature: 100 °C-480 °C
- Temperature stability: +/- 2 °C
- Potential between tip and ground: < 2mV
- The resistance between tip and ground: < 2 Ohm
- Iron: 907 F
- Soldering iron power: 50 - 100 W
- Display: LCD
- Soldering station Yihua 872D+
- Set of nozzle:
- round nozzle with a diameter of 2 mm
- round nozzle with a diameter of 4.4 mm
- round nozzle with a diameter of 6 mm
- round nozzle with a diameter of 9 mm
- Standfor the soldering iron along with a cleaning sponge
- A gripper for lifting circuis
- Soldering iron 907 F with tip I
First run
- You should not run the device immediately after delivery.
- Equipment must remain for about 12 hours at room temperature before switching on.
- All complaints caused by running of the equipment too soon will be denied.
- You must completely remove the screw/screws from the bottom of the station if the compressor is the source of air supply. These screws are marked in red (1 or 3 screws depending on model).
Note
Heating elements (heaters) and tips are not subject to warranty, you should purchase new ones.
Our range of accessories for soldering:
- soldering tin of various diameters
- fluxes and rosins
- braids to remove excess tin
- suckers
- soldering tips
- tweezers, holders, magnifying glass
- sponges and cleaners