Характеристики
- Напряжение до
- 220 V AC
- Напряжение от
- 240 V AC
- Лаборатория будущего
- Compatible
- Припой - Горячий воздух
- yes
- Кондиционер паяного типа
- Цифровой
- Припой - показания реальной температуры
- yes
Общие характеристики
- Паяльник - Вентилятор
- yes
Прочие свойства
- Бренд
- YIHUA
Свойства
- Температура
- 200 - 480 °C
Энергопитание
- Номинальная мощность
- 700 W
- Номинальное напряжение
- 230 V AC
Описание
Description
Station Yihua 898BD has two LED displays, which can read the temperature of hot air and flask soldering iron. Temperature adjustment is done using buttons, airflow with knob.
The device has sensor in the mount that, when putting off flask, the station cooles the heating element.
Stable and effective airflow is provided through a fan located in the flask. The fan is driven by a brushless motor, which provides a much higher durability and reliability of the device.
Check out our offer of additional tips!
Specification- Supply voltage: 230 V / 50 Hz (network)
- Power: 700 W
- The control is performed using PID controller
- Protection ESD Safe
- Automatic cooling of the heating elements after station's shutdown
- The station has an ergonomical body
Hotair Soldering Iron
- Adjustable temperature of hot air from 100 °C to 480 °C
- Temperature stability +/-1 °C
- LED display
- Temperature setting with buttons
- Smoothly adjustable airflow via knob
- Airflow up to 120 l/min
- The venting is provided through a fan located in the knob
- The flask 907A
- Regulation of the soldering tip temperature from 200 °C to 480 °C
- Capacity: 50 W
- Temperature stability: +/- 2 °C
- The potential between tip and ground: up to 2 mV
- The resistance between tip and ground: 2 Ohm
Includes:
- Station Yihua 898BD
- Stand for the flask hotair
- Set of nozzles:
- round with a diameter of 6 mm
- round with a diameter of 9 mm
- square 12x12 mm
- Stand for the grotto flask along with a cleaning sponge
- The grotto flask 907 A with a tip T-I
- A gripper for lifting chips
First run
- After delivery of equipment, it should not be immediately started.
- Equipment must remain about 12 hours at room temperature before switching on.
- All applications for damages caused by the premature commissioning of the equipment, will be denied.
- You must completely remove the screw/screws from the bottom of the station if the source of an air supply is compressor. These screws are marked in red (1 or 3 screws depending on model).
Note
Heating elements (heaters) and the tips are not subject to warranty either expressed or implied, and replacing them is chargeable.
Our range of accessories for soldering:
- solders - tins of various diameters
- fluxes and calaphonies
- braid to remove excess of tin
- evacuators
- soldering tips
- forceps,holders, magnifiers
- sponges and cleaning cloths