Soldering station 2in1 hotair and tip-based Zhaoxin 852D compressor - 330W
Бестселлер
- Артикул:
- 47170585
59 655 AMD
Характеристики
- Напряжение до
- 220 V AC
- Напряжение от
- 240 V AC
- Паяльник - Вентилятор
- Нет
- Припой - Горячий воздух
- yes
Общие характеристики
- Кондиционер паяного типа
- Цифровой
- Припой - показания реальной температуры
- yes
Прочие свойства
- Бренд
- Zhaoxin
Свойства
- Температура
- 200 - 480 °C
Энергопитание
- Номинальная мощность
- 330 W
- Номинальное напряжение
- 230 V AC
Описание
Description of Soldering station 2in1 hotair and tip-based Zhaoxin 852D compressor - 330W
The station has built-in dual LED display informing you of a preset temperature of hot air and tip-based soldering iron. The device also has a power adjustment of hotair. The air flow is performed through the compressor.
Zhaoxin 852D has anantistatic designed. It has the ESD Safefunction, which protects the soldered items from damage. Wide application and low failure rate of the device gives it a leading position on the market of soldering station.
Check out our offer of additional tips!
Specification: Soldering station 2in1 hotair and tip-based Zhaoxin 852D compressor - 330W- Supply voltage: 230 V / 50 Hz (network)
- Power:330 W
- The station has an ergonomical body
- Station isESD Safe(protection from damage to the CMOS chip using electrostatic charge)
Hotair Soldering Iron
- LED display that indicates the temperature of the hot air
- Power:270 W
- Air consumption:24 l/min
- Adjustable air supply with regulator
- To stabilize the temperatureregardless of air flow rate
- The system is ESD Safe(protection from collecting static charge)
Soldering Iron Tip-based
- Regulation of the soldering tip temperaturefrom 200 °C to 480 °C
- Soldering iron power 60 W
- LED display that indicates the temperature of the soldering iron
- The supply voltage of iron: 24 V
Included
- Soldering stationZhaoxin 852D
- Stand for the tip-based iron along with a cleaning sponge
- Stand for the hotair iron
- Power cable
- The user manual
- Set of nozzles:
- Round nozzle with a diameter of 2 mm
- Round nozzle with a diameter of 7 mm
- Round nozzle with a diameter of 9 mm
First run
- You should not run the device immediately after delivery.
- Equipment must remain for about 12 hours at room temperature before switching on.
- All complaints caused by running of the equipment too soon will be denied.
Note
Heating elements (heaters) and the tips are not subject to warranty, and you must purchase new ones.
Our range of accessories for soldering:- soldering tin of various diameters
- fluxes and rosins
- braids to remove excess tin
- suckers
- soldering tips
- tweezers, holders, magnifying glass
- sponges and cleaners
