Pogo pins and mounting accessories - for HAT and Raspberry Pi Zero / Zero W - PiMoroni PIM330

Pogo-a-go-go Solderless GPIO Pogo Pins set by PiMoroni. Designed for the Raspberry Pi Zero / Zero W , it allows you to attach the HAT overlay to the module, which has no pins. Pogo pins are resilient and allow for a perfect fit of the elements (without the need for additional tools ). They are also durable, so they enable frequent prototyping and changing the design concept.

Pogo-a-go-go Solderless GPIO Pogo Pins - pogo pins and mounting accessories for HAT and Raspberry Pi Zero / Zero W - PiMoroni PIM330.

Pogo-a-go-go Solderless GPIO Pogo Pins kit contents.

• Type: pogo pins and mounting hardware
• Purpose: for mounting HATs with Raspberry Pi
• Compatible RPI Model: Raspberrry Pi Zero / Zero W
• Mounting accessories material: nylon
• Color: white and gold
• Pogo Pin Length:
  • about 9.5 mm when extended
  • about 7 mm when compressed

• 10x GPIO pogo pins
• 4x white M2.5 x 12 mm nylon mounting screws
• 4x white M2.5 x 7 mm nylon spacers
• 5x white M2.5 nylon nuts

• Find the pins used by the overlay you want to match on pinout.xyz
• Insert the four screws through your RPi's mounting holes (from the bottom)
• Put on the four nuts from the top
• Place the pogo pins with the short end in the GPIO RPi in the corresponding holes you read on pinout.xyz
• Place the HAT overlay on top
• Secure the pad with the four nuts on the mounting holes

• Manufacturer's website: PiMoroni PIM330
• The arrangement of the pins in the Raspberry Pi Zero / Zero W