Quick connector with solder + heat shrink foil 3mm - 5pcs.

Heat shrinkablequickconnector with length 40 mm and inner diameter 3 mm,has a ring withtinembedded in the tube. It is designed to connect wires with cross section from 0,5 to 0,1 mm2. Heat the tube to above80°C.The tin will start to melt and permanently connect the wires together. There is an extra layer of adhesive inside the quick connector to protect the wires from moisture. No more insulation is needed for the wires.

Quick disconnect with tin + heat shrink foil 22 - 18 AWG 0,5 - 0,1 mm2.

Instructions on how to properly connect the quick connector to the wires.

1. Remove the insulation from the ends of the two wires.
2. Pass one of the wires through the quick-connect.
3. Connect the two wires together and place the tin strip in the center of the quick disconnect.
4. Weld the heat shrink tubing.

• Connects wires without soldering
• Seals and insulates wires against water, dirt and disconnection
• Contains inside thermo-melting glue

• Insulating material: polyolefin
• Working temperature: from -55°C to 125°C
• Tube shrinking temperature: 80°C
• Additional adhesive layer
• Colour: red
• Cable cross-section: from 0,5 to 0,1 mm2
• Outer diameter: 4 mm
• Inner diameter: 3 mm
• Tube length: 40 mm

Set contains 5 pieces of quick disconnects.