Electromagnet holding 12V 3W 20kgf

Holding electromagnet , powered by 12 V. With a standard acceleration due to gravity of 9.8 m/s 2 it supports a mass of 20 kg . The current consumption during operation of the device is approximately 250 mA, the nominal power is 3 W. The device has an M4 installation hole in the housing, and the set also includes an appropriate mounting screw. The electromagnet has dimensions: 34 x 17 mm. The length of the cables with the insulation removed is approx. 30 cm. If you use the device as an actuator controlled by Arduino , remember not to connect it directly to the microcontroller pins. For proper operation of the system, it is necessary to use a relay , opto-isolator or transistor amplifier .

Holding electromagnet 12V 3W 20kgf .

Electromagnet holding a load .

• Supply voltage: 12V
• Power: 3W
• Current consumption: approx. 250 mA
• Load capacity: 20 kgf (holds a mass of 20 kg for a gravitational acceleration of 9.8 m/s 2 )
• Cables with stripped insulation at the ends, approx. 30 cm long
• Mounting hole with M4 thread (screw included)
• Dimensions: 34 x 17 mm
• Weight: 83 g

Attention !

The manufacturer recommends maintaining good heat dissipation from the housing, because as the coil temperature increases, the holding force decreases.

• Load capacity diagram of electromagnets