Electromagnet holding 12V 3,5W 30kgf

Holding electromagnet with a rated power of 3.5 W. Powered by 12 V. Current consumption is approximately 300 mA. The device maintains a mass of 30 kg under standard acceleration due to gravity. The product has an installation hole with an M5 thread in the housing, and the set also includes an appropriate mounting screw. The electromagnet has dimensions: 40 x 20 mm. The length of the cables with the insulation removed is approx. 30 cm. The device is used as an actuator controlled by Arduino . Due to the high power consumed by the electromagnet, it should not be connected directly to the microcontroller pins. This may result in damage to the system. In such connections, an additional element should be used: a relay , opto-isolator or transistor amplifier .

Holding electromagnet 12V 3.5W 30kgf .

Electromagnet holding a load .

• Supply voltage: 12V
• Power: 3.5 W
• Current consumption: approx. 300 mA
• Load capacity: 30 kgf (holds a mass of 30 kg for a gravitational acceleration of 9.8 m/s 2 )
• Cables with stripped insulation at the ends, approx. 30 cm long
• Mounting hole with M5 thread (screw included)
• Dimensions: 40 x 20 mm
• Weight: 140 g

Attention !

The manufacturer recommends maintaining good heat dissipation from the housing, because as the coil temperature increases, the holding force decreases.

• Load capacity diagram of electromagnets