M1U256 - single-channel motor controller 48V/2,2A with connectors - UART interface - Pololu 5062

A driver based on the M1U256 system that allows you to control one DC motor. It uses the UART TTL interface for communication. The module can work with motors supplied with a voltage of 4.5 V to 48 V. The maximum output current per motor is 2.2 A. The controller also withstands current spikes of up to 6.4A for a few seconds. The user can connect several controllers to the same TTL serial bus and extend the project with additional motors. The board has soldered goldpin connectors .

M1U256 - single-channel motor driver DC 48 V / 2.2 A with connectors - UART interface - Pololu 5062.

The driver is based on the M1U256 chip.

• Control of one DC motor
• UART interface
• Soldered goldpin connectors
• Ability to connect multiple controllers to one serial bus and extend the project with additional motors
• Protection against reverse voltage on the motor supply up to 40 V
• Optional Cyclic Redundancy Check (CRC)
• Configurable motion parameters:
  • maximum acceleration/deceleration
  • initial speed
  • direction change delay
• Eight PWM frequency options from 1kHz to 80kHz
• Protection in case of connection loss
• Configurable automatic error response
• Engine supply voltage measurement (VIN)
• Informative LEDs

• Number of channels: 1
• Supply voltage: from 4.5 V to 48 V
• Operating voltage of the logic part: from 3.0 V to 5.5 V
• Continuous current: 2.2A
• Maximum instantaneous current: 6.4 A
• PWM frequency: 1kHz to 80kHz
• Dimensions: 15.24 x 15.24mm
• Weight: 1.9g

The module has soldered goldpin connectors.

• Manufacturer's website - Pololu #5062
• User Guide
• Library for Arduino
• Library for Raspberry Pi
• Module diagram