M1 SATA drive mounting kit - for Odroid M1 minicomputer

A kit that allows you to mount a 2.5-inch SSD or HDD on Odroid M1 - a single- board minicomputer equipped with a whole range of interfaces. Provides approximately 500 MB / s sequential access. A separate external 12V SATA power supply is required to use the 3.5 inch hard drive. The set includes the HDD Holder, mounting screws and spacers, a power cord and a data cable.

The contents of the mounting kit for the SATA M1 drive.

Installation instructions.

1. Connect the power cord and the SATA data cable to the Odroid M1 minicomputer. Unscrew the two black screws and screw the mounting spacers included in the kit.
2. Use the two black screws to connect the HDD Holder and SSD as in picture B.
3. Connect the other side of the power cord and SATA data cable to the SSD.
4. Attach the HDD Holder to the drive and replace the two black screws.
5. Keep the wires in a safe place.

• HDD Holder - 1 piece
• Power cord - 1 piece
• Data transfer cable - 1 piece
• Mounting screws - 5 pieces
• Mounting spacers - 3 pieces

Odroid M1 is a single- board minicomputer equipped with a Cortex-A55 quad-core processor (with low energy consumption and high performance) and a Mali-G52 graphics processor. Odroid M1 has 8 GB of RAM and a connector for eMMC memory and microSD cards , Ethernet slot, HDMI and USB 3.0. There is an efficient heat sink around the module, which helps to cool the entire system during operation.

Odroid M1 - minicomputer with Rockchip RK3568B2 processor + 8 GB RAM.