Limit switch - endstop - for 3D printers - Creality

Limit switch (Endstop) is an element used in3D printerstostop moving parts of the system- such as carriage or table movements. It also allows detection of the moment when the X, Y or Z axes reach theirextreme positions(maximum and minimum setting). A built-in lever increases the braking distance of the mechanism and leaves a possible margin for error. The limiters are a very good safety device which prevents the moving element from exceeding the limit position. Lack of such protection could causedamage to the printerand its environment. The module has a built-in female 3-pin socket, by means of which it should be connected to the main board. The set does not contain a suitable connection cable.

Limit switch - for 3D printers - Creality.

The module is equipped with a 3-pin female socket.

• Type: limit switch
• Purpose: for 3D printers
• Compatible printers: Creality CR-10, Creality CR-10-S4, Creality CR-10-S5, Creality CR-10S, Creality Ender 3, Creality CR-10S Pro, Creality Ender 3 Pro, Creality CR-20 Pro, Creality Ender 5, Creality CR-X, Creality CR-10 Max, Creality CR-10S Pro V2, Creality CR-10 V2, Creality Ender 5 Pro, Creality Ender 5 Plus, Creality CR-10 Mini, Creality Ender 3 V2, Creality CR-6 SE, Creality CR-10 V3
• Original spare part used by 3D printer manufacturer Creality
• Installed in almost all Creality FDM printers
• Connector: 3-pin female sockets
• Sensor dimensions: 20 x 25 x 8 mm
• Mounting hole spacing: 15 mm
• Number of pieces in set: 1 pcs.

• S - signal
• G - system ground
• V - power supply

• Limit switch - for Creality 3D printers
• Assembly elements - screws - 2 pieces.

Mounting holes spacing allows for easy installation of the sensor.

• Manufacturer's website: Creality