Iduino Nano - compatible with Arduino + USB wire
- Артикул:
- 42762953
Характеристики
- UC - I2C
- yes
- UC - PWM
- 6
- UC - UART
- yes
- UC - ядро
- 8-bit AVR, 1. Single Core
- UC - EEPROM
- 1 kB
- UC - частота
- 16 MHz
- UC - Вспышка
- 32 kB
- Напряжение от
- 12.0 V
- Напряжение до
- 7.0 V
- UC - аналог в
- 8
- Интерфейс UC - SPI
- yes
- UC - Микроконтроллер
- ATmega328
- Выходное напряжение от
- 5.0 V
- Выходное напряжение до
- 5.0 V
- UC - Цифровые контакты
- 14
- UC - оперативная память
- 2 kB
Общие характеристики
- UC - USB
- miniUSB
Прочие свойства
- EAN
- 5903351241748
- Бренд
- Iduino
Энергопитание
- Номинальное выходное напряжение
- 5.0 V
Описание
Iduino module is equipped with Atmega328 microcontroller compatible with Arduino Nano. It can be programmed via Arduino IDE environment using available libraries.
MiniUSB cable included.
The board contains Atmega328 microcontroller equipped with 14 digital inputs/outputs, 6 of which can be used as PWM outputs (e.g. to control motors) and 8 as analog inputs. The chip is clocked by a 16 MHz clock signal.
Iduino Nano programmingFree Arduino IDE environment allows creating and installing software. Implemented bootloader allows to upload program directly via USB cable.
Iduino Nano module specifications- Supply voltage: 7 V to 12 V
- Pins operate at 5 V
- Fully compatible with Arduino Nano
- Microcontroller: Atmega328
- Clock frequency: 16 MHz
- SRAM memory: 2 kB
- Flash memory: 32 kB (4 kB reserved for bootloader)
- EEPROM: 1 kB
- I/O ports: 14
- PWM outputs: 6
- Number of analog inputs: 8 (A/D converter channels)
- Serial interfaces: UART, SPI, I2C
- External interrupts
- Connector: miniUSB type B socket(USB cable included)
- Power supply possible from USB port
- Automatic selection of power supply source
- Soldered ISP connector
- Dimensions: 45 x 18 mm
- Weight: 5 g
We offer unique Iduino Nano module which is compatible with popular Arduino Nano. The device uses the same Atmega328 microcontroller and takes very little space (45 mm x 18 mm).
There are 14 digital I/O ports on the board, 6 PWM channels (can be used, for example, to control a motor or the intensity of light emitted by LEDs) and 8 analog inputs (for example, to connect analog sensors).
Module compatible with Arduino NanoThe device operates from 7 V to 12 V, while the leads are already 5 V. Compatibility with Arduino Nano, is not only the possibility to use the same software and programming environment (Arduino IDE). The device uses UART, SPI and I2C serial ports and is equipped with miniUSB socket.
First of all, it's worth remembering that GPIO pin layout in Iduino is also the same, so Arduino overlays will also fit Iduino.
Useful links- Manufacturer web site
