Fermion - LCD IPS TFT 1.8'' 128x160px SPI display - DFRobot DFR0928

The Fermion LCD TFT IPS display is based on the ST7735S driver, its diagonal is 1.8 " , and the resolution is 128 x 160 px . It uses a 4-pin SPI interface for communication. The built-in microSD memory card slot allows easy reading of color bitmaps from the memory card In order to connect the display with the main module, two methods can be used: standard connection via SPI or GDI (General Display Interface). The module can be easily connected to FireBeetle using the FPC tape. The board works with a voltage from 3.3 V to 5 V and draws up to 0.11 W of power.

• 128 x 160 px resolution
• 4-wire SPI communication
• Integrated microSD card slot

• Display of measurement data from sensors, alarm
• Arduino temperature monitoring
• Fan controller

The Fermion display module for communication uses a 4-wire SPI interface. Works with a voltage from 3.3 V to 5 V. Can be connected to the FireBeetle module using the FPC tape.

• VCC - power supply from 3.3 V to 5 V
• GND - the ground of the system
• SCLK - clock line of the SPI bus
• MOSI - receiving SPI data
• MISO - sending SPI data
• CS - layout selection
• RES - reset
• DC - data / commands
• BLK - backlight
• SDCS - microSD card layout selection

Fermion - LCD IPS TFT 1.8 '' 128x160px SPI display - DFRobot DFR0928.

• Working voltage: from 3.3 V to 5 V
• TFT viewing angle: 120 °
• Number of pixels: 128 columns x 160 rows
• Communication: SPI
• Interface type: GDI, pin connector
• Driver chip: ST7735S
• Power consumption: 0.11 W
• MicroSD card slot
• Operating temperature range: -10 ° C to 60 ° C
• Display area size: 26 x 35 mm
• Module dimensions: 34 x 55 mm
• Mounting hole spacing: 29 mm, 50 mm
• Mounting holes diameter: 2 mm

• 1x Fermion - LCD IPS TFT 1.8 '' 128x160px SPI display - DFRobot DFR0928
• 1x GDI cable
• 1x 10-pin connector

• The website of the manufacturer: DFRobot DFR0928
• Diagram
• Documentation of the ST7735S
• 3D file
• 2D file