DRV8833 DC/Stepper Motor Driver Breakout Board - Adafruit 3297
- Артикул:
- 42766897
Характеристики
- Напряжение до
- 2.7 V
Общие характеристики
- Напряжение от
- 10.8 V
Прочие свойства
- Бренд
- Adafruit
Свойства
- Каналы
- 2
Энергопитание
- Сила тока
- 1.2 A
Описание
The module based on the DRV8833 chip allows you to control two DC motors or one stepper motor. The motor can be powered from 2.7V to 10.8V with continuous current consumption up to 1.2A per channel, temporary (for a few seconds) up to 2A.
Product compatible with Arduino
Manufacturer provides user guide with program for Arduino.
Motor driver specifications- Number of channels: 2
- Supply voltage: from 2.7 V to 10.8 V
- Operating voltage of the logic part: from 2.7 V to 10.8 V
- Continuous current per channel: 1.2 A
- Maximum current per channel: 2 A
- PWM control
- Thermal protection
- Overcurrent protection
- Dimensions: 26 x 18 x 3 mm
- Weight: 1.5 g (without connectors)
- Included module and goldpin and screw connectors
The chip has holes for soldering 2.54mm goldpin and screw connectors. All connectors are included.
PIN DescriptionVMotor
Supply voltage for motors from 2.7 V to 10.8 V. GND Module ground. AIN1, AIN2Inputs to control motor A by PWM signal.
Connected to the microcontroller.
BIN1, BIN2Inputs for controlling motor B by PWM signal.
Connected to the microcontroller.
FLTOutput that goes low when a fault is detected.
Should be connected to the power supply through a resistor.
STBYPin switching off the device. It should be connected to the power supply
in order to turn it on. Default is off.
The pinouts are standard goldpin strips and screw connectors, allowing the module to be plugged into a contact board or connected via wires.
Useful links- Adafruit 3297 manufacturer website
- User guide
- Documentation and schematics