DRV8256E - single-channel motor controller 48V/1,9A - Pololu 4038
Бестселлер
- Артикул:
-
47399051
10 789 AMD
Старая цена
12 347 AMD
Характеристики
Общие характеристики
- Напряжение до
- 4.8
Прочие свойства
- EAN
- 5903351244800
- Бренд
- Pololu
Энергопитание
- Сила тока
- 1.9 A
Описание
Product description: DRV8256E - single channel motor driver 48 V / 1,9 A - Pololu 4038
A small, single-channel DC motor driver. The DRV8256E module developed by Pololu is powered from 4.5 V to 48 V. Continuous current per channel is 1.9 A (momentary up to 6.4 A for 1 second). It allows simple control of speed and direction of motor rotation, using only two microcontroller pins. The controller is also equipped with protection against reverse polarity, too low voltage, too high current and too high temperature.
Single channel DC motor driver - DRV8256E.
Connection of DRV8256E motor driver.
Connection of DRV8256E motor controller
Supply motor voltage from 4.5 V to 48 V to the VIN pin. In a typical application, it is sufficient to connect two control lines: PHASE direction selection and PWM speed control to the ENABLE pin. Both lines are internally pulled up to ground through a resistor. SLEEP pin allows to switch the chip into low power mode. A low state must be specified to enter sleep mode.
DRV8256E truth table
ENABLE
PHASE
OUT1
OUT2
MODE OF OPERATION
PWM
1
PWM (H/OPEN)
L
Forward / deceleration at PWM speed %.
PWM
0
L
PWM (H/OPEN)
Reverse / Disengage at PWM speed % PWM
0
X
OPEN
OPEN
enable / IDLE (output off)
Outputs of the DRV8256E controller
Pin
Default state
Description
VIN
Input voltage from 4.5 V to 48 V.
GND
System ground for the motor and logic.
VM
Pin giving access to the motor power supply after the MOSFET reverse voltage protection. It can be used to power other elements of the system with reverse polarity protection.
OUT1
Motor 1 output.
OUT2
Motor 2 output.
EN
LOW
Activates the input for output activation / motor speed control. A high state causes the motor to run. Controlled by PWM.
PH
LOW
Phase input to control the direction of rotation of the motor.
FAULT
FLOATING
Open-drain, fault output activated by a low state. Pin goes low when current or voltage is exceeded. Must be pulled up with a resistor to default to the high state.
SLEEP
LOW
The SLEEP input causes the controller to go into a low power state when the low state is applied. This pin can also be toggled to clear a locked overcurrent or overtemperature fault.
VREF
Current limiting threshold reference voltage.
DRV8256E motor controller specifications
- Number of channels: 1
- Supply voltage: 4.5 V to 48 V
- Continuous current per channel: 1.9 A
- Instantaneous current per channel: 6,4 A
- Maximum PWM frequency: 100 Hz
- Minimum logic voltage: 1.8 V
- Maximum logic voltage: 5,5 V
- Reverse polarity protection
- Dimensions: 15.2 x 15.2 mm
- Weight: 0,6 g
Schematics of the DRV8256E controller.
Useful links
- Manufacturer's site: Pololu #4038
- Diagram
- Dimensions
- 3D model
