DFRduino Nano V4.0 - compatible with Arduino Nano
- Артикул:
- 99446836
Характеристики
- UC - PWM
- 6
- UC - USB
- microUSB
- UC - I2C
- yes
- UC - ядро
- 8-bit AVR, 1. Single Core
- UC - UART
- yes
- UC - EEPROM
- 1 kB
- UC - Вспышка
- 32 kB
- UC - частота
- 16 MHz
- Напряжение до
- 7.0 V
- Напряжение от
- 12.0 V
- UC - аналог в
- 8
- Интерфейс UC - SPI
- yes
- UC - Микроконтроллер
- ATmega328
- Выходное напряжение от
- 5.0 V
- Выходное напряжение до
- 5.0 V
- UC - Цифровые контакты
- 14
Общие характеристики
- UC - A/C
- 10-bit
- UC - оперативная память
- 2 kB
Прочие свойства
- Бренд
- DFRobot
Свойства
- Номинальное выходное напряжение
- 5.0 V
Описание
TheDFRobot module equipped with an Atmega328-20AU microcontroller, compatible with Arduino Nano. This means that it can be programmed throughthe Arduino IDEusing available libraries. To connect DFRduino Nano to the computer, sufficient is micro-usb cables.
The board contains the Atmega328-20AUmicrocontroller, equipped with 14 digital I/o, 6 of which can be used as PWM outputs (e.g. for motor control) and 8 as analog inputs. The system works with the clock signal with the frequency of 16 MHz.
In order to start Bluno, you need to connect the system to the computer usingthe microUSB cableand select inthe Arduino IDE, the Arduino Nano board.
ProgrammingCreating and installing the software is allowed by the free environment of the Arduino IDE. Implemented bootloader allows you to send the program directly via USB cable.
Specification- Supply voltage: 7 V to 12 V
- Leads operate at a voltage of 5 V
- Fully compatible with Arduino Nano
- Microcontroller: Atmega328-20AU
- Clock frequency: 16 MHz
- SRAM: 2 KB
- Flash memory: 32 KB (2 KB is reserved for bootloader)
- EEPROM: 1 KB
- I/O ports: 14
- PWM outputs: 6
- Number of analog inputs: 8 (channels of the A/C converter)
- Serial interfaces: UART, SPI, I2C
- External interrupts
- Connector: microUSB type B socket (USB cable not included)
- Power supply from USB connector
- Automatic selection of power supply
- Soldered ICSP connector
- Dimensions: 45 x 18 mm
- Weight: 30 g
Useful links
- The website of the manufacturer: DFRobot DFR0010
- Wiki Doc Guide
- Software Arduino IDE
- Documentation of the programming language
- FAQ
- Documentation for the Atmega328
