Badger 2040 - board with RP2040 and e-paper 2,9'' 296x128px display - Pimoroni PIM607

Badger 2040 was created by the Pimoroni company in honor of the 10th anniversary of the Raspberry Pi. The board is based on a dual-core RP2040 ARM Cortex M0 + microcontroller clocked at 133 MHz with 264 KB of SRAM and 2 MB of QSPI flash memory with XiP support. The module has a monochrome e-paper screen with a diagonal of 2.9 " and a resolution of 296 x 128 px . There are 5 buttons on the front of the board, while on the other side you can find the GPIO pins, JST battery connector, Qwiic / Stemma QT, USB type C and two buttons.

Badger 2040 - board with RP2040 and 2.9 '' e-paper screen, 296x128px - Pimoroni PIM607

The e-paper screen with which the board is equipped can also be found in e-book readers. These types of displays do not strain the eyes, which makes them ideal for reading long texts. These types of screens consume a small amount of energy, and after disconnecting from the power supply, they still display the last image. The screen used on the board has a diagonal of 2.9 "and a resolution of 296 x 128 pixels, and the distance between pixels is 0.227 x 0.226 mm. The screen displays the image in shades of black and white.

The Badger 2040 board is based on the RP2040 chip, which is programmed in C / C ++, MicroPython and CircuitPython. The manufacturer has prepared C ++ and MicroPython libraries along with sample program codes.

• MicoPython by Pirate
• Badger 2040 User Guide
• C ++ examples
• MicroPython examples
• MicroPython Functions

You can also use CircuitPython together with Adafruit libraries.

• CircuitPython for Badger 2040
• User Guide of CircuitPython
• CircuitPython examples
• BadgerOS ported to CircuitPython by Stephane BeBoX

• Screen: black and white e-paper 2.9 ", 296 x 128 px
  • ultra wide viewing angle
  • ultra low power consumption
  • pixel pitch 0.227 x 0.226 mm
• Chip: RP2040 dual-core ARM Cortex M0 + clocked at 133 MHz
• SRAM memory: 264 kB
• Flash memory: 2 MB QSPI with XiP support
• Five user buttons on the front
• Reset and boot buttons
• White LED
• USB Type-C connector for power and programming
• JST-PH connector for connecting the battery (from 2.7 V to 6 V)
• Battery level monitoring
• Qwiic / Stemma QT connector for I2C modules and sensors
• Fully assembled

• Badger 2040 - board with RP2040 and 2.9 '' e-paper screen 296x128px - Pimoroni PIM607

• Manufacturer's website: Pimoroni PIM607
• User Guide
• Diagram
• Technical drawing
• C ++ / MicroPython libraries