Arduino Pro Mini 328 module - 5V/16MHz - SparkFun DEV-11113
- Артикул:
- 47397963
Характеристики
- UC - I2C
- yes
- UC - A/C
- 10-bit
- UC - PWM
- 6
- UC - UART
- yes
- UC - ядро
- 8-bit AVR, 1. Single Core
- UC - EEPROM
- 1 kB
- UC - частота
- 16 MHz
- UC - Вспышка
- 32 kB
- Напряжение до
- 5.0 V
- UC - аналог в
- 8
- Интерфейс UC - SPI
- yes
- UC - Микроконтроллер
- ATmega328
- Выходное напряжение от
- 5.0 V
- Выходное напряжение до
- 5.0 V
- UC - Цифровые контакты
- 14
- UC - оперативная память
- 2 kB
Прочие свойства
- Бренд
- SparkFun
Энергопитание
- Номинальное выходное напряжение
- 5.0 V
Описание
Arduino Pro Miniis based on popular Uno module. The board containsATmega328 microcontroller, equipped with 14 digital inputs/outputs, 6 of which can be used as PWM outputs (e.g. to control motors) and 8 analog inputs. The chip is clocked at 16 MHz, operates at 5.0 V, has 32 kB of Flash program memory and 2 kB of SRAM. UnlikeArduino Pro, Arduino Pro Minidoesn't have any connectors, so it's very small. User decides, which pins he needs.
Module doesn't include goldpin connectors. You can buy them by clicking here.
Module is made on 0.8 mm thick laminate.
- Supply voltage: from 5V to 12V
- Microcontroller: ATmega328
- Maximum clock frequency: 16 MHz
- SRAM: 2 kB
- Flash memory: 32 kB (5 kB reserved for bootloader)
- EEPROM: 1 kB
- I/O pins: 14
- PWM channels: 6
- Number of analog inputs: 8
- Serial interfaces: UART, SPI, I2C
- External interrupts
- Protection against too high current flow
- Module made on 0,8 mm thick laminate
- Weight less than 2 g
- Dimensions: 33 x 18 mm
This version works with 5.0 V at 16 MHz. We also offerPro Mini 3.3 V / 8 MHz module. To program this board you needUSB to UART converter.
If supply voltage is higher than 5V, connect it to RAW pin, which is connected to regulator. VCC is connected directly to microcontroller pins, connecting voltage higher than 5.0V may permanently damage the chip.
Creating and uploading software is possible usingfree environmentprovided by manufacturer. This board doesn't have USB interface controller. That's whyUART to USB adapteris required for programming. You should start programming Arduino Pro Mini by buying adapter.
- Manufacturer's website: SparkFun DEV-11113
- Getting started
- Software
- Schematics of the module
- Eagle program files
- Programming language documentation
- Documentation Atmega328
