Arduino Ethernet Shield 2 with microSD reader- A000024

The module is an extension for moduleArduino that connect to Ethernet network. The service is simplified by the library together with intuitive documentation and numerous examples. Shield is also a reader of microSD memory cards, which allows to store more data.

The subject of the sale is only the shield. The Arduino Uno can be purchased separately in our store.

• Working voltage: 5 V (powered from Arduino pins)
• Ethernet controller: W5500 with buffer of 32 KB
• Data transfer rate: 10/100 MB
• Communication: SPI bus
• Built-in microSD memory card reader
  • Available from the level of a standard SD Card library
  • Pin SS of the SPI bus is at the pin no. 4
• Built-in RJ45 connector
• The possibility to connect the module PoE- power over Ethernet
• The module has the following status LEDs:
  • ON - signals the proper powering
  • LINK - indicates a connection to the network
  • FDX - indicates the connection in full duplex mode
  • 100M - indicates the communication with the speed of 100 Mbit/s
  • ACT - flashes when using pins RX and TX
• Led out RESET button of the Arduino
• Shield is compatible withArduino UnoandMega(does not support Arduino Zero Pro M0)

In addition to the Ethernet slotr and the card reader, device has: connectors for PoE module, leads of Arduino pins, RESET button, LEDs, and additional slots to the communication buses, for example, TWI (I2C).

ThingSpeak platform for Arduino and Raspberry Pi IoT.

• Product page
• The Arduino IDE
• Documentation of the system W5500
• Diagram of the module
• Eagle program files